Back To The Family Handyman
Del.icio.us
Digg
Reddit
Facebook
StumbleUpon
TwitThis
Steps 11 - 14
11. Trim back the faucet supply lines to about 7 and 8 in. Then install the faucet and sink tailpiece following the manufacturer’s instructions.
12. Smear pipe dope onto the
threads of the supply line compression fittings and tighten them onto the
faucet supply lines.
Click image to enlarge.
13. Slip the sink over the
mounting bolts and finger-tighten the mounting nuts over the washers. Lift the
sink slightly while tightening the nuts with a wrench.
14. Bend the supply lines
gently to meet the supply valves at a right angle. Mark and cut the tubing even
with the bottom of the threads on the valves.
Advertisement 
