Fix a Clogged Toilet (page 2 of 3)

Do You Have a Slow Drainer or a No-Drainer?

A poor flush means that your toilet drain is either partially or completely plugged. A toilet that’s completely plugged—a no-drainer—is obvious. The toilet bowl will fill to the brim with flush water and perhaps overflow. Give the water level 10 minutes or so to drop, then attack the problem with a plunger (Photo 1).

However, most clogged toilets are slow drainers, that is, flush water partially fills the bowl but doesn’t rush out and clean away the waste. The water level remains high, then usually drains down to normal height within a minute or two. You might not know the toilet is clogged until you flush it. So if you suspect a problem, test the drainage first as we show in Photo 2. If it doesn’t drain, don’t flush it. Reach for the plunger.

Click image to enlarge.
1. Plunge the toilet with the rubber flange pulled out to get a better seal. Push in and out vigorously, keeping enough water in the bowl to cover the plunger. Keep towels handy to wipe up water that splashes out.

Become a Master Plunger
Photo 1 shows how a plunger fits over and seals the toilet drain. Wear rubber gloves—things can get messy—and follow these plunging tips:

1. Make your first plunge a gentle one. Initially the bell is full of air. A hard thrust will force the air back around the seal and blow water all over the bathroom and you!

2. Once you force out the air, plunge vigorously in and out, maintaining the seal. You’ll be forcing water both directions in the drain, which will effectively loosen most clogs. Stick with it, plunging 15 to 20 times if necessary.

3. Be patient. Try alternating between steady strokes and occasional monster heaves.

4. Keep enough water in the bowl so the plunger stays covered. Trying to force air through the toilet trap won’t generate much pressure.

Most of the time, this is all it takes to clear the clog. However, if the plunger won’t open the drain, or if you can force out the water with the plunger but the toilet still won’t flush well, reach for the snake (Photos 3 and 4).

2. Don’t flush the toilet if you suspect that it’s clogged. Instead, remove the tank lid and lift the flapper valve slightly to let a cup or two of water into the bowl to see if the water goes down. Flushing a clogged toilet may flood your floor!

•  

• Clear Clogged Drains
• How to fix clogged sinks and tubs with a plunger and a snake.
• 
• Remodel a Small Bathroom
• Update your bathroom with a new wall-hung sink, hidden-tank toilet and glass block window.
• 
• 
• 
• 14 Tips for Health-Friendly Cleaning
• You may not realize it, but your house is hazardous to your health.
• 
• Organizing The Bathroom
• Learn how to create vanities and extra storage spaces that can help organize any bathroom.
• 

I knew immediately I was in one of those fancy food boutiques when I saw the sign over the express lane. Instead of reading "15 items or less," it said "15 items or fewer."

-- Jay Richards, Menlo Park, Calif.