Back To The Family Handyman
From 
Del.icio.us
Digg
Reddit
Facebook
StumbleUpon
TwitThis
Over time, door handles loosen and become difficult to turn and unlatch. Most door hardware made today uses exposed screws, accessible from the “room side” of the door, to connect the two halves of the handle to each side of the door. But some current brands (and most older door hardware) use hidden chassis screws (Photo 2), a setup that requires you to take the doorknob and rose (cover plate) apart to tighten the screws. Photos 1 and 2 show you how.
Our door hardware is fairly typical, but you may have something other than a button to release the knob. Also, some door roses unscrew from the chassis by hand (turn them counterclockwise) rather than snap onto it.
1. Remove the inside doorknob by locating the button (like our model), metal tab or wire clip on the side of the knob that acts as a release. Using an awl or small screwdriver, push the button in all the way—and at the same time—pull off the handle. Remove the door rose by inserting a small screwdriver into the small notch in the rose and twisting the tool to pop it off. Be careful so you don’t chip any door paint.
2. Tighten the door hardware by opening the door, squeezing both sides of the assembly together and tightening
the two screws on the chassis. To reassemble, snap the rose back on the chassis, depress the release button and slide the knob back on until the button pops through the hole.
Advertisement 
