Halloween Napkin Rings

These napkin rings draw oohs and aahs of delight from party guests due to their bright colors and bold designs.

From Halloween! Your Best Ever
Advertisement
 
Image

You Will Need

  • 2 D-rings (11⁄2” or smaller) per napkin ring
  • Approximately 10” of ribbon per napkin ring
  • Craft brads, tacky glue, or glue gun and glue sticks

    What to Do
    1. Insert one end of ribbon through both D-rings, wrap around, leaving 1⁄2-inch of ribbon. Secure, using brads, tacky glue, or glue gun. (Using decorative brads adds an attention-­grabbing playful detail to the finished product. To add a brad, make a very small cut with a craft knife, insert the brad, and then spread open its prongs to secure it.)

    2. Finish the other end of the ribbon by folding it over (1⁄2 inch) onto itself and securing it.

    3. To use: With the good side out, wrap the ribbon around a rolled-up napkin (including the silverware within the napkin roll works well for buffet-style service). Insert the end of the ribbon through both D-rings. Then fold the end back and in between the D-rings, and pull up on the end to adjust to fit the napkin.
From Halloween! Your Best Ever
 
Must Read Should Everyone Read This? Yes! I vote for this story
Share Your Comments
 
Remaining Character Count:
 
See All Comments

Advertisement
 
Related Links

Get It Through E-mail

Get info and tips you can really use!
Sign up to receive the This Week@RD newsletter.


Advertisement
Popular stories from the source site rd.com sorted by diggs