Step-by-Step Instructions and Pictures of Table Saw Tips and Tricks

by Eric Smith
Make cleaner, safer and straighter cuts with easy-to-make accessories and jigs for your table saw. Read an overview of table saw tips and tricks.
From The Family Handyman
Previous
Table Saw Tips and Tricks
Image 12 of 12
Trim crooked boards with a plywood straight edge, cont'd
Make the sliding plywood straightedge from a 1-ft. x 8-ft. strip of 3/4-in. plywood. Attach the rough board to the plywood with screws driven (predrilled) through a waste section. If there’s not enough waste area, screw up through the plywood into the rough board and fill the small holes later. Or consider using special surface-mounted holddown clamps, available from woodworking stores.
M Box
Share Your Comments
Remaining Character Count:
 
Privacy Policy
 

Advertisement

Advertisement