Back To The Family Handyman
Del.icio.us
Digg
Reddit
Facebook
StumbleUpon
TwitThis
Repair a Leaking Tub Faucet: What You Need
You can fix most problems with the replacement parts available at hardware stores and home centers. A plumbing parts distributor will carry a much larger selection and may be able to special-order hard-to-find items (look under “Plumbing Parts and Supplies” in your local Yellow Pages).
There are thousands of different faucet replacement parts available, so bring your old parts to the store for a proper match. If your valve is highly corroded or the finish is wearing off, replace the entire faucet.
Removing the faucet handle is the toughest part of the job. Over time, corrosion can virtually weld the handle to the stem. Remove the handle. If the handle won’t come off, don’t force it—it might break. Instead, remove it with a special handle puller ($10 to $20).
Once the handle’s off, unscrew the escutcheon and stem assembly. The stem assembly controls the amount and temperature of the water dispensed through the tub spout or shower head. Remove it with a special bath socket wrench, which looks like a spark plug wrench on steroids.
Leaks usually occur for two reasons. Over time, the seat washer stiffens and won’t seal tightly. And water pressure gradually erodes the brass rim of the seat. Replace the seat using a special seat wrench ($10 to $20).
Fig. A shows the stem replacement parts and how to prepare the stem for reinstallation. Lubricate the parts with special plumber’s grease. If you’re working on a two-handled faucet, we recommend replacing the washers and seats in both the hot and cold valves.
Stem Assembly And Replacement Parts
To Replace The Stem Parts:
Unscrew the packing nut. Twist the stem clockwise and back it out of the bonnet. Pry out the old packing washer with a small flat-blade screwdriver or pick. Grease the stem threads and reinstall the stem in the bonnet. Grease the new packing washer and slide it in place, and then grease the packing nut threads and firmly tighten the packing nut. Use special plumber’s grease.
Remove the old seat washer screw and the old seat washer. Grease the new seat washer and the threads of the new screw and then reinstall them.
Pull off the old bonnet washer, grease the new one and slide it in place.
Apply pipe joint compound to the bonnet threads and reinstall it in the faucet body.
Grease the handle splines and replace the escutcheon and handle.
Advertisement 
