• Join Now
• |
• Sign In

Toenailing Techniques and Tips

Determine the angle to use for maximum holding power when toenailing wood framing.

By the experts at The Family Handyman

From The Family Handyman

Images from this article

javascript:void(0);

About This Project

• Overview and Preparation

• See More Tools
  

Q   Call me a rookie, but I was wondering if there is a right (or wrong) way to toenail 2x4 studs or joists into plates?

A   For maximum holding power, the rule of thumb to remember is to drive the nail (as shown) at a 30-degree angle to the 2x4. Start it approximately one-third the length of the nail from the end of the piece.

From The Family Handyman - November 2004

• • Tools
• • Wood Furniture

• How to Remove Stuck Nails
• Here are tips for pulling tough, stubborn nails out of wood.
• 
• How to Use Pocket Screws
• This ingenious fastening system simplifies all types of wood joints. No fancy joints to cut, no clamps to install, no dowels or biscuits. Just drill and screw for a strong, tight joint.
• 
• Comparing Palm Nailers And Nail Guns
• Air-powered (pneumatic) nailers offer different benefits.
•